![Sheetcam youtube](https://kumkoniak.com/76.jpg)
I've also found that I have to set my THC voltage setting to about half what I've seen others using (60V) in order to keep the nozzle anywhere near the 0.06" cutting height. It has very little in the way of suggested parameter settings info. The Everlast cutter is not what I would have chosen, but it came with the table. I have an almost identical setup (Mach3, G540, Proma THC-150, floating head torch mount, Everlast Powerplasma 60S c/w machine torch). I am very interested in the outcome of this thread. tap files with the old post that I know worked and see what happens. This is the first time I have ran the machine with the MP1000-THC post also. With the plasma on, it would not go past the M03 code at all. When it got to the point where it would stop (M03), I could hit the start function again and it would continue on with the program until it got to the M03 code again.
![sheetcam youtube sheetcam youtube](https://pekoeblaze.files.wordpress.com/2020/04/brutal-doom-v21-gold-plutonia-beginning.jpg)
With the Plasma OFF I could run the program.
![sheetcam youtube sheetcam youtube](https://i.ytimg.com/vi/t6C1e5RRj_U/maxresdefault.jpg)
Then it would stop when it gets the the M03 line of code. When I did run it with the THC on, the torch would touch off and come to correct pierce height and then start the torch. I will try that tomorrow and see what happens. I did not try running it with the THC off. I did find when I unhooked it (the Arc Okay), the manual torch on/off function in Mach3 started working correctly again. I had it connected to the output for the torch on at the G540. I am thinking it is something in my Mach3 setting, I just don't know what. I did try a different Post but it does the same thing. And the torch on/off will not cut the torch off. The torch is on but it will not lower to cut height or do anything. When I turn on the plasma, it touches off to set the height then it starts the torch. I ran a couple of test cuts with the Plasma turned off to make sure it run though the code and it did. But, when I try to toggle the torch off it does not turn off. The first issue I have is I turned every thing on and triggered the torch on to make sure the Proma is reading. I added the settings in Mach3 for the THC. I have it wired to the machine and the G540.
![sheetcam youtube sheetcam youtube](https://media.moddb.com/cache/images/downloads/1/96/95667/thumb_620x2000/moddb_reader.jpg)
![sheetcam youtube sheetcam youtube](https://i.ytimg.com/vi/YgGRVI3LMh8/maxresdefault.jpg)
I am in the process of installing the Proma THC. I have had the plasma running for a while until now. I am Using the cutmaster 42 with the Proma 150 THC and the Gecko G540.
![Sheetcam youtube](https://kumkoniak.com/76.jpg)